Control instruments

Throughout the whole production chain is carried out quality controls to ensure maximum reliability of the finished product.
At the end of the cycle every single element is subject to dimensional, metallurgical and structural analysis to verify the correspondence with initial standards.

The characteristics of this system of production allow the designer to create complex geometric shapes that cannot be reproduced with the classical machining. Allow the designer the possibility to create the object with all kinds of steels and alloys.

To obtain good quality castings is therefore required careful planning, taking into account the flatness tolerances, angular and imposed by this production system. To this end, our technicians are at your disposal to determine the geometry of the product and for choosing the most suitable material for the solution of your problem.