The
quality and reliability of a finished workpiece for the use
it is meant to are mainly granted by a process control in every
manufacturing step. Therefore, during the whole production iter
the single steps are inspected and monitored by means of state-of-the-art
equipment and severe procedures.
At the end of a cycle, each item is submitted to further through
chemical analyses and non-destructive tests in order to check
its conformity to the relevant buyer's requirements according
to acceptance criteria.
The
quality and reliability of a finished workpiece for the use
it is meant to are mainly granted by a process control in every
manufacturing step. Therefore, during the whole production iter
the single steps are inspected and monitored by means of state-of-the-art
equipment and severe procedures.
